esphome:
  name: bedroom_tkm1
  platform: ESP32
  board: esp32cam
  on_boot:
    - priority: 900 #900 tried down to 500
      then:
        - lambda: |-
            id(wake_up_reason) = log(esp_sleep_get_ext1_wakeup_status())/log(2);

wifi:
  ssid: "Meneely"
  password: "punxsutawney1"

  # Enable fallback hotspot (captive portal) in case wifi connection fails
  # ap:
  #   ssid: "BigBlue1 Fallback Hotspot"
  #   password: "QNWj7LmaNoD6"
  manual_ip:
    # Set this to the IP of the ESP
    static_ip: 192.168.87.36
    # Set this to the IP address of the router. Often ends with .1
    gateway: 192.168.86.1
    # The subnet of the network. 255.255.255.0 works for most home networks.
    subnet: 255.255.254.0
  fast_connect: True

# captive_portal:

# Enable logging
logger:
    level: INFO

# Enable Home Assistant API
api:

ota:

mqtt:
  broker: 192.168.86.99
  discovery: True
  username: ha
  password: lorrie
  # keepalive: 2s
  birth_message:
          topic: bedroom_tkm1cam/status
          payload: coming_online_birth
  will_message:
          topic: bedroom_tkm1cam/status
          payload: going_offline_will
  on_message:
    topic: bedroom_tkm1/ota_mode
    payload: 'ON'
    then:
      - deep_sleep.prevent: deep_sleep_1

deep_sleep:
        run_duration: 20s
        sleep_duration: 24h
        esp32_ext1_wakeup: 
                pins: 
                  - 13 #yellow
                  - 12 #orange
                  - 15 #green
                mode: ANY_HIGH
        id: deep_sleep_1

globals:
        - id: wake_up_reason
          type: int
          restore_value: no
          initial_value: '0'
sensor:
  - platform: template
    name: "Remote Control Wake Reason"
    accuracy_decimals: 0
    lambda: |-
            return id(wake_up_reason);

    # on_value:
    #   then:
    #     - if:
    #         condition:
    #           lambda: 'return id(wake_up_reason) == 4;'
    #         then:
    #           - logger.log: "4, yellow wire touched"
    #         else:
    #           - logger.log: "Non-yellow wire touched"

binary_sensor:
  - platform: gpio
    pin: 
        number: GPIO13
        mode: INPUT_PULLUP
    # filters:
      # - delayed_on: 10ms ### <---- debounce time, was 100ms
      # - delayed_off: 10s ### <---- delay to capture state change on wake up         
    name: "TKM Test 13 (yellow)"
    id: tkm_test_13
  - platform: gpio
    pin: 
        number: GPIO12
        mode: INPUT_PULLUP
    name: "TKM Test 12 (orange)"
    id: tkm_test_12
  - platform: gpio
    pin: 
        number: GPIO15
        mode: INPUT_PULLUP
    name: "TKM Test 15 (green)"
    id: tkm_test15