esphome:
  name: bedroom_tkm1
  platform: ESP32
  board: esp-wrover-kit
  on_boot:
    priority: 900
    then:
      - lambda: |-
          id(wake_up_reason) = log(esp_sleep_get_ext1_wakeup_status())/log(2);

wifi:
  ssid: "Meneely"
  password: "punxsutawney1"

  # Enable fallback hotspot (captive portal) in case wifi connection fails
  # ap:
  #   ssid: "BigBlue1 Fallback Hotspot"
  #   password: "QNWj7LmaNoD6"
  manual_ip:
    # Set this to the IP of the ESP
    static_ip: 192.168.87.36
    # Set this to the IP address of the router. Often ends with .1
    gateway: 192.168.86.1
    # The subnet of the network. 255.255.255.0 works for most home networks.
    subnet: 255.255.254.0
  fast_connect: True

# captive_portal:

# Enable logging
logger:
    level: INFO

# Enable Home Assistant API
api:

ota:

mqtt:
  broker: 192.168.86.99
  discovery: True
  username: ha
  password: lorrie
  keepalive: 2s
  birth_message:
          topic: bedroom_tkm1/status
          payload: coming_online_birth
  will_message:
          topic: bedroom_tkm1/status
          payload: going_offline_will
  on_message:
    topic: bedroom_tkm1/ota_mode
    payload: 'ON'
    then:
      - deep_sleep.prevent: deep_sleep_1

deep_sleep:
        run_duration: 20s
        sleep_duration: 1min #24h
        esp32_ext1_wakeup: 
                pins: #[12] #, 14, 27]
                  - GPIO12
                  - GPIO14
                  - GPIO27
                mode: ANY_HIGH
        id: deep_sleep_1

globals:
        - id: wake_up_reason
          type: int
          restore_value: no
          initial_value: '0'

sensor:
  - platform: template
    name: "Remote Control Wake Reason"
    accuracy_decimals: 0
    lambda: |-
            return id(wake_up_reason);
    on_value:
      then:
        - if:
            condition:
              lambda: 'return id(wake_up_reason) == 12;'
            then:
              - logger.log: "12, Green wire touched"
            else:
              - logger.log: "Non-green wire touched"

binary_sensor:
  - platform: gpio
    pin: 
        number: GPIO12
        mode: INPUT_PULLUP
    filters:
      - delayed_on: 10ms ### <---- debounce time, was 100ms
      # - delayed_off: 10s ### <---- delay to capture state change on wake up         
    name: "TKM Test 12 (Green)"
    id: tkm_test_12
  - platform: gpio
    pin: 
        number: GPIO14
        mode: INPUT_PULLUP
    name: "TKM Test 14 (Yellow)"
    id: tkm_test_14
  - platform: gpio
    pin: 
        number: GPIO27
        mode: INPUT_PULLUP
    name: "TKM Test 27 (Orange)"
    id: tkm_test27