Setting up new standards, and new Lilygo Chip for buttonbox

bedroom_lilygo_t7v15.yaml

@@ -0,0 +1,97 @@
+substitutions:
+  device_name: bedroom_tkm_lily1
+  device_ip: 192.168.87.44
+
+esphome:
+  name: ${device_name}
+  platform: ESP32
+  board: esp32dev
+  on_boot:
+    - priority: 900 #900 tried down to 500
+      then:
+        - lambda: |-
+            id(wake_up_reason) = log(esp_sleep_get_ext1_wakeup_status())/log(2);
+
+wifi:
+  ssid: !secret wifi_ssid
+  password: !secret wifi_password
+  manual_ip:
+    static_ip: ${device_ip}
+    gateway: 192.168.86.1
+    subnet: 255.255.254.0
+  fast_connect: True
+
+# captive_portal:
+
+# Enable logging
+logger:
+    level: INFO
+
+# Enable Home Assistant API
+api:
+
+ota:
+<<: !include standard_mqtt.yaml
+# mqtt:
+#   broker: !secret mqtt_broker
+#   discovery: True
+#   username: !secret mqtt_username
+#   password: !secret mqtt_password
+#   # keepalive: 2s
+#   birth_message:
+#           topic: ${device_name}/status
+#           payload: coming_online_birth
+#   will_message:
+#           topic: ${device_name}/status
+#           payload: going_offline_will
+#   on_message:
+#     topic: ${device_name}/ota_mode
+#     payload: 'ON'
+#     then:
+#       - deep_sleep.prevent: deep_sleep_1
+
+deep_sleep:
+        run_duration: 20s
+        sleep_duration: 40s #24h
+        esp32_ext1_wakeup: 
+                pins: 
+                  - 33 #yellow
+                  - 34 #orange
+                  - 35 #green
+                mode: ANY_HIGH
+        id: deep_sleep_1
+
+globals:
+        - id: wake_up_reason
+          type: int
+          restore_value: no
+          initial_value: '0'
+sensor:
+  - platform: template
+    name: "Remote Control Wake Reason"
+    accuracy_decimals: 0
+    lambda: |-
+            return id(wake_up_reason);
+
+binary_sensor:
+  - platform: gpio
+    pin: 
+        number: GPIO33
+        mode: INPUT_PULLUP
+    # filters:
+      # - delayed_on: 10ms ### <---- debounce time, was 100ms
+      # - delayed_off: 10s ### <---- delay to capture state change on wake up         
+    name: "TKM Test 33 (yellow)"
+    id: tkm_test_33
+  - platform: gpio
+    pin: 
+        number: GPIO34
+        mode: INPUT_PULLUP
+    name: "TKM Test 34 (orange)"
+    id: tkm_test_34
+  - platform: gpio
+    pin: 
+        number: GPIO35
+        mode: INPUT_PULLUP
+    name: "TKM Test 35 (green)"
+    id: tkm_test35